You can override the default sheet metal.
Autodesk inventor sheet metal flange.
On the ribbon click sheet metal tab create panel contour flange.
Notice in the first photo that the slotted hole is off center.
When creating a flange of an offset width you select only a single edge.
Upon measuring the slots are correct to the flange but the flange is not centered on the sheet.
I did not realize it until i used the part in an assembly.
A flange feature consists of a face and bend connected to an existing face along a straight edge.
Although the sheet metal face feature may be considered the most fundamental of sheet metal features sheet metal parts consisting of a single face are in the minority.
The sheet metal flange feature consists of a face and bend connected to an existing face along a straight age.
Use the flange command to add a sheet metal face and a bend to an existing sheet metal face.
Learn more about the flange feature in this vi.
Set a distance for the height of the flange or select to and select geometry to define.
If there are two or more solid bodies in the part file click the solids selector to choose the participating solid body.
You can specify the depth and the angle of the flange and whether it is created inside or outside the existing face.
On the ribbon click sheet metal tab create panel flange.
You can override the default sheet metal style settings using the unfold options and the bend or corner tabs on the feature creation dialog box.
Sheet metal flange features consist of a face and bend connected to an existing face along a straight edge.
Flange features are added by selecting one or more edges and specifying a set of options that determine the size and.
To add a flange feature you select one or more edge and specify a set of options that determine the size and position of the material added.
I added a flange a couple actually to a part and two of them did not center properly.
Click an open profile.
I am using inventor 2019.
Project sheet metal flange to plane at that point i hadn t seen the image you posted so i didn t know where the reference plane was in relation to the flange.
The edge select mode is active.
Create a contour flange.
Create a flange and define its width as an offset.
Create a 2d open profile sketch.
A flange feature consists of a face and bend connected to an existing face along a straight edge.
Create sheet metal flange along edge on the ribbon click sheet metal tab create panel flange.
Corners that generate during the creation of flange and contour flange features display the default corner relief shape when the model is flat.
To add a flange feature you select one or more edges and specify the size and position of the material added.
