Gap between the end of the ledger and the ends of siding and fill it with high quality exterior caulk to keep water from leaking behind the ends of the ledger.
Attaching a ledger to house with wood siding.
Place a level horizontally on the siding against the bottom of the threshold and center the bubble.
Start by making an outline on the siding where you want to position the ledger board.
To ensure proper strength a ledger board should be made out of the same size lumber that was used to make the deck joists usually 2 inch by 10 inch boards.
Make sure you have enough room to install flashing above the ledger board and allow for at least a space above the decking preventing water from wicking upwards into wood siding.
Make a mark where the top of the deck should be the mark should be 1 3 inches below that.
Set the blade depth so you won t cut into the house sheathing below the siding.
Snap a chalk line cut out the siding and tack up the ledger board.
Next snap a chalk line across the siding the same length of the board.
Step 3 add 2 x 8 planks between joists.
Wood or concrete siding will have to be cut away using a circular saw.
Mark the ledger length.
A ledger relies on the fasteners and strength of the wood ledger board and rim board of the house to carry the deck live and dead loads.
Attaching a deck ledger securely is only half the work of installing a ledger.
Anchor deck joists to the ledger with joist hangers filling each hole with galvanized joist hanger nails rated for pressure treated wood.
Most house framing relies on building elements floors walls roofs being stacked one atop another.
Properly installing a ledger board for your deck is one of the most important structural components of building a safe and strong deck.
Avoid cutting the house wrap beneath.
Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.
Measure the length and width of your deck to attach the ledger correctly.
Locate the rim joist and mark an outline on the siding where you want to position the ledger board using a tape.
Cut away the marked area of siding with tin snips.
Then slip flashing behind the siding covering the top edge of the ledger.
4 place the ledger board flat against the house with its.
Cut a length of metal z flashing.
Trace its top edge onto the siding.
How to attach a ledger board to a vinyl sided house 1.
How to attach ledger board on siding mark the top of the ledger.
Measure the exact width and length of the ledger board with a tape measure.
